Problem in 10892 H

[Jerry2020]

Re: Problem in 10892 H

Yes one can be to mount the dish updown side, but so you can't use it on motor. I mean you can mount the dish updown side on pole, so the dish will be pointed much high in elevation so to avoid terrestrial interferences. Look this pic to know better what I mean.

http://img167.imageshack.us/img167/5798/pict1628cf9.jpg

http://img524.imageshack.us/i/dcp2752ms3.jpg/

If you'll mount the dish so the elevation will be high and you'll need to calculate it by yourself but like you see expecially into second pic, the dish will be avoid all terrestrial interferences because it will point straight to sky.

Thanks but I can't cancel the motor

[zoran89]

Re: Problem in 10892 H

Well it isnt much you will miss if you dont have this transponder.

[Jerry2020]

Re: Problem in 10892 H

I don´t know.
Or try to move the dish to another location ??

Thanks but I can't move it

Well it isnt much you will miss if you dont have this transponder.

Yes, but the problem is almost in all satellites. Not just this tp on nilesat.

Has anyone else experienced such problem.

[zoran89]

Re: Problem in 10892 H

If you have wireless phone try to unplug him from electricity and test then this freqency.

[skytec]

Re: Problem in 10892 H

I think it´s a good idea. Maybe try turn off all electric device and switch on satelitte reciver only...

[Resident]

Re: Problem in 10892 H

I know it's a 180cm dish but your flag says you're in Argentina. Nilesat as far as I know has very limited footprint. I think it's perfectly normal that you cannot receive some of the TPs.

Does the signal strength change during day or night? Is it stronger or weaker at certain hours?

[Jerry2020]

Re: Problem in 10892 H

If you have wireless phone try to unplug him from electricity and test then this freqency.

I don't have, but if a neighbor has one could it interfere?

I think it´s a good idea. Maybe try turn off all electric device and switch on satelitte reciver only...

I went over the roof of the building and tried to connect directly dish to box and had the same result.
Could there be interference from the top floor of the building or something?

[Resident]

Re: Problem in 10892 H

Well, it could be basically anything. Wireless phones (not cellphones) could only interfere if they use the same frequency which I highly doubt. If it's one of those block houses with cellphone boosters on top that could be a problem. Although I would rule out that one as well cause you only have problem with this particular transponder and it's highly unlikely that something interferes only with one single transponder.

[yselim]

Re: Problem in 10892 H

are you using one cable. by saying one cable i mean cable without cable additions. the more you have connection points the more your signal will be effected by interference. did you bypass the motor when you went over the roof. try to attcach one cable(without additions) to directly lnb. dont use any switches or motor.what is the result? and i also want to ask your cable quality. use rg6 u6 grade cable. what is your cable quality?

[Jerry2020]

Re: Problem in 10892 H

are you using one cable. by saying one cable i mean cable without cable additions. the more you have connection points the more your signal will be effected by interference. did you bypass the motor when you went over the roof. try to attcach one cable(without additions) to directly lnb. dont use any switches or motor.what is the result? and i also want to ask your cable quality. use rg6 u6 grade cable. what is your cable quality?

Yes, it's one cable, one piece no connections.
And I connected the lnb with one small cable to the box and there was no signal.
This is on nilesat. For the rest of satellites, the signal is weaker than other transponders too.

[yselim]

Re: Problem in 10892 H

- you said that people who live near you had no such problem. maybe your tv is the interference source. have you ever consider that.

-you said that you tried other boxes. were they all same brand-model.(which has same model tuner)

-have you tried moving the receiver in your home. does that make any change.

finally if nothing helps make a box, cover it with aluminum foil. put your receiver into that box to protect it from interference. nothing comes my mind other than these.

[uttnls]

Re: Problem in 10892 H

Hello all
I have a problem with the transponder 10892 H 27500 on Nilesat and on most other satellites.
On nilesat, I can receive all channels except this one. On other satellites, this transponder or close ones are very weak. Though I don't have problems with other transponders, and the dish is 180cm.
I can't figure out the reason.
Any help would be appreciated.

I gues you have a DECT phone near or a wireless router or somthing based on Wireless or bluetooth.

If you have a DECT phone just unplug the base station and scan the tranponder and you'll see a huge difference :P

I still have this problem.
Any ideas?

One bet on the DECT PHONE who's with me ?

[odysseas1991]

Re: Problem in 10892 H

Your LNB is what is likely to be at fault since you cannot recieve a strong signal for any satellite. Try a newer LNB, if it is dish related then maybe you have set up the dish with the wrong angles. It is highly sensitive the difference between a strong and weak signal so make sure you have it aligned perfectly on a perfectly straight upright and find your angles with an online calculator.

[peremacedonia]

Re: Problem in 10892 H

If transponder is with low signal and your antena is not set corectly u will resive others signals bud in this transponder signal will be to low for recive picture.
I have no signal on one tansponder and when i check dish i get picture,The wind may defocus lnb and here is problem

[Jerry2020]

Re: Problem in 10892 H

- you said that people who live near you had no such problem. maybe your tv is the interference source. have you ever consider that.

-you said that you tried other boxes. were they all same brand-model.(which has same model tuner)

-have you tried moving the receiver in your home. does that make any change.

finally if nothing helps make a box, cover it with aluminum foil. put your receiver into that box to protect it from interference. nothing comes my mind other than these.

-My TV is far from the dish. I tried another small one when I tried to connect directly to the dish.

-I tried different brands.

-I'll try that aluminum trick.

Thanks

I gues you have a DECT phone near or a wireless router or somthing based on Wireless or bluetooth.

If you have a DECT phone just unplug the base station and scan the tranponder and you'll see a huge difference :P

One bet on the DECT PHONE who's with me ?

I have wireless router. I unplugged it, but with the same result. But I think other people in the building have wireless routers. Could this affect the dish?

Your LNB is what is likely to be at fault since you cannot recieve a strong signal for any satellite. Try a newer LNB, if it is dish related then maybe you have set up the dish with the wrong angles. It is highly sensitive the difference between a strong and weak signal so make sure you have it aligned perfectly on a perfectly straight upright and find your angles with an online calculator.

Actually this is the new lnb.
It is fuji.
It has the same problem as the old one.