Multifeed 19.2E+23.5E+28,2E+39E?

[iliyavet]

My location is central Bulgaria, with 80 cm.offset dish ,and currently I using 19+23 multifeed and working perfect.Is it possible to try to extend to 39E?For me important is 23.5E and 39E ,but I have 4 LNB and diseq 4/1 and want to include free LNB for 19 and 28E.Is anybody tried that?

[microchick]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

The amount of money you spend on 4 feed, you could easily buy a good quality motor and go motorised. It will give you much more choice.
Multi feed only gives you fast zapping. Motorised dish will give you a big variety from west to east and a huge number of channels.

[cisko]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

20° are a lot but on the most important online auction site you can find.
I prefer toroidal dished due to high range available and quality of signal, but toroidal dish cost much more than a simple offset dish.

Remember that on an offset dish any lnb different from primary that be into primary focus has a signal attenuation.

Of course a motorized dish is a better (or the best) idea if you have only one decoder and don't do zapping, if you have more than one receiver, or a multi tuner receiver and you would view channel on sat1 and record another channel on a different satellite you can use only diseqc.

[bokkie]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

20 degrees on an 80 cm dish might be a bit of a stretch. Best to either get another dish or a motor i reckon.

[skytec]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

Set the dish to 28.2 and the other LNB set to another satellite.
Fine-tune to the strongest signal.
I'm afraid that in the outer position will signal without reserve.

[mirny]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

i think you can do it i've got on my 85cm dish multifees from 5e to 12,5w
a there is still some reserve. satelites that you choose have got good signal strenght, so you can do it, give that 28w to the midle. I can recomend to you a mutifeed holder vantage or emme esse you can turn lnbs in threee ways.

[iliyavet]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

Today if a weather is good, i will try,yesterday was raining . I know this is a verry difficult task,but nothing is impossible
Have a nice day to all,when i finish with setup i will tell you for the result. Crossing fingers

For the moment I have been setup 19,23 and 39
Signal on 39 is a 45-55 % (weather in the moment is not raining but is still cloudy not clear visibility to sky) -I check the signal with progfinder (I using skystar2 hd usb) only transponders with HD programs on 39 have not signal anothers transponders having signal and i can watch programs
On 19 and 23 signal is very good - 70-90% depend of transponders
Now..... I can't find signal on 28 ( i dont know witch transponder to scan - who is with strongest signal?

P.S Sorry for the grammar and language I hope you understand me

[toby69]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

Now..... I can't find signal on 28 ( i dont know witch transponder to scan - who is with strongest signal?

--------------------------------------
iliyavet, just a tip.

when setting up new satellite on your system, always use a fta transponder number, they normally the strongest, (to get you started).

[iliyavet]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

I do it!!! ,but I setting LNB's for 13-19,2-23,5-39E - working perfect,only on 13E the signal is little weak on some transponders,but does not matter,for me important was to use 23,5 and 39E .
Best regards!

[mirny]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

I can't find signal on 28 ( i dont know witch transponder to scan - who is with strongest signal?

I'm using as a referential TP this one:
DVB-S 11,222 H 27500 2/3
that one is quite strong, when you find it, try to find this
DVB-S 11,307 V 27500 2/3
this one is weak, so then tune this
but forget about UK beam

[kalpikos]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

Dear iliyavet

First of all Congratulation for your courage and patience to do this project.
I'm sure that you have spent a lot of your time in order to align the dish.

In past , I was made a lot of experiments and one of these it was the same project as your's.
I remember that the results it was "good" but not enough "good" for me.
I mean that the signal it was very poor and that's way I desided to do another project...

I put 2 dishes of 1.20 cm .
The first, has center the 19.2E and also has lnb's for 13E + 9E +10E + 4.8E
The second, has center the 28.2E and lnb's for 23.5E + 42E +39E

The reception of this project is excellent!!!
All transporters can be received without any problem.

You will need a new dish , 4 new slim lnb's and a diseqc 8x1.
Of course you can choise to put your lnb's at diferent satelites as in this way you have many options.

Best regards

[easydigital]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

I have a 1.20 cm motor dish set at 28E with solo2&uno so after read in your posts Multifeed is faster so I try in to setup LNB's for 13-19 4.8E and 08w use in a Camera Stand....

[zoran89]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

There should be no problem. I had 1W, 13E, 16E, 19E on 80cm dish and it worked great.

[mirny]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

I have a 1.20 cm motor dish set at 28E with solo2&uno so after read in your posts Multifeed is faster so I try in to setup LNB's for 13-19 4.8E and 08w use in a Camera Stand....

this is a good solution, you can connect motor through diseqc
and watch favourite positions with quick access, and if you want hunt signal, you can move wherever

[Satphoenix]

Re: Multifeed 19.2E+23.5E+28,2E+39E?

I have a 85cm dish and 4 sats from 13° to 42°.
It's working good, but depends on your position and the signal strength (db) you can receive there.
For this watch the pics with the db-lines on the homepages of the sats.