Tweet
Connect PC and receiver with serial cable and a crossover network cable nullmodem
if decoder direct PC-to-pin or pins if using a router or switch
a decoder off
Start DM800-repair
start DreamUP_patched_by_forhike_and_natas
click on the DM800-repair center and proceed as a normal dreamUp
that is, click connect and power the decoder
at the end you will see the progress bar as if by magic on the display of the decoders' recive IP,
at this point or continue with the same or Flashwizard DreamUp
if decoder direct PC-to-pin or pins if using a router or switch
a decoder off
Start DM800-repair
start DreamUP_patched_by_forhike_and_natas
click on the DM800-repair center and proceed as a normal dreamUp
that is, click connect and power the decoder
at the end you will see the progress bar as if by magic on the display of the decoders' recive IP,
at this point or continue with the same or Flashwizard DreamUp
