Can not get SkyGrabber with SkyStar S2 to work

[SatWaveDude]

I've been trying to get SkyGrabber to work with SkyStar S2 PCI card but with no luck

First I could get no signal from my LNB via a diseqc switch.
But I found the the problem that was in conflict with SkyGrabber.
It was caused a conflict by a software from TechniSat:

Name: Server4PC
The file is: Server4PC.exe

This software is automatic started when you boot your system.

When you close this (Server4PC) file SkyGrabber wil see signal.

Are there any additional drivers that I have to install to get it to work?

[ftaboy]

Re: Can not get SkyGrabber with SkyStar S2 to work

I've been trying to get SkyGrabber to work with SkyStar S2 PCI card but with no luck

First I could get no signal from my LNB via a diseqc switch.
But I found the the problem that was in conflict with SkyGrabber.
It was caused a conflict by a software from TechniSat:

Name: Server4PC
The file is: Server4PC.exe

This software is automatic started when you boot your system.

When you close this (Server4PC) file SkyGrabber wil see signal.

Are there any additional drivers that I have to install to get it to work?

yes the problem of conflict signal is with TechniSat software, the Server4PC trying to lock on other frequency and the Skygrabber try to lock another frequency at the same time , when you close Sever4PC its ok, so , btw , you can go to : Run > msconfig > startup , to disable Server4PC to not run on windows startup....
you dont need any other additional driver the driver is installed is okay. but i recommend you use SkyNet for sat fishing because it use lower resource than SkyGrabber , presonally i was had a lot of problem with it, sky net is the best.
regards

[SatWaveDude]

Re: Can not get SkyGrabber with SkyStar S2 to work

I spend a lot of time trying to get SkyGrabber to work but without success.
I'm gona try SkyNet and post my findings here.