DVBViewer Signal Meter for dish setup?

[jochen7575]

Hello,

is there is a possibility to see the signal meter at dvbviewer bigger to set up the dish, or is there a plugin?

Thanks

[besit]

Re: DVBViewer Signal Meter for dish setup?

Nothing can be worst than use dvbiewer for finding a satellite
- If you have a DVBcard with the Name (Technotrend, Technisat etc) - use fastsatfinder (in my case - TeVII 660S it works very unstable)
- You can use DVBDream with included plugin, showing signal strength full screen
- You can use signal strength/quality meter in AltDVB - good enough, et last - MyTheater's.

[jochen7575]

Re: DVBViewer Signal Meter for dish setup?

OK, then I have to search of another way. I have a dreambox, I will ask at the dreambox forum for a possibility.
Thanks.

[carburo218]

Re: DVBViewer Signal Meter for dish setup?

I use prog finder works well.

[metalchef]

Re: DVBViewer Signal Meter for dish setup?

try Fast SatFinder!
I use it and is perfect

[stu667]

Re: DVBViewer Signal Meter for dish setup?

Hello,

Dvbs cards for pc are generally less sensitive than a box. You will struggle a lot for a bad result.

I learned to setup my dish with a TV and my box. The fine tune can be done with ios app or android app using your phone or tablet.

After it's done, you just have to plug your Pc device and it should be ok.

[zokis7]

Re: DVBViewer Signal Meter for dish setup?

Try to find installed ProgDVB with channel selected (when you start ProgDVB it remembers last selected channel). Best way is to navigate motor or dish with channel selected. Even if you are close to position of that transponder you will hear scratching sound that you are near to the position. All signal indicators are 2-3 seconds latethen actual signal level.

Best way is to be positionet to some free channel and move the dish or motor.

[stu667]

Re: DVBViewer Signal Meter for dish setup?

Try to find installed ProgDVB with channel selected (when you start ProgDVB it remembers last selected channel). Best way is to navigate motor or dish with channel selected. Even if you are close to position of that transponder you will hear scratching sound that you are near to the position. All signal indicators are 2-3 seconds latethen actual signal level.

Best way is to be positionet to some free channel and move the dish or motor.

I assume that you have your computer right next to your dish? Otherwise it seems to be hard to setup a dish

[zokis7]

Re: DVBViewer Signal Meter for dish setup?

Turn speackers volume to maximum, if you are not alone is OK.