Alert: Don't Use Hotmail Email Accounts for registration
Collapse
Before Access to all Forums and Trial accounts you must need to activate your account Email address
slow ECM times
Collapse
X
-
Re: slow ECM times
SatWaveDude
DM500HD, DM500+ | EMP S16/1PCP-W3 | WaveFrontier T90 | 16x SMART Titanium 0.1dB LNB's
TechniSat SkyStar S2 PCI / SkyStar USB HD
WaveFrontier T90 rev.2 - 28.2E | 23.5E | 19.2E | 16E | 13E | 10/9E | 3.3E | 4/5E | 0.8W | 7/8W | 12.5W
If you find my post usefull please press the Thanks ButtonComment
-
Re: slow ECM times
Client side config requires ip and port used by oscam's monitor but also requires that oscam admin allows your ip.
Tell him to refer to monitor section of oscam.conf.
With oscaminfo working, you can compare the ecm time when originating from oscam server and the correspondig ecm time when arriving to your receiver.
The difference is the delay introduced by the network/hops.
This is the only way to evaluate and check if and where you can improve the overall performance.Comment
-
Re: slow ECM times
@gianni253 thanks for that, will give it a go when i have some time.
on a different note, my ECM times are much improved lately.
i changed rehares and hop counts down and my ECM's are clearing much much faster.
i suspect my link was just being overloaded a bit with requests.
thanks to all for the comments and suggestions.Comment
Comment