Welcome!

Welcome to Satlover forums, full of great people, ideas and excitement.

Please register if you would like to take part. link..

Register Now

Alert: Don't Use Hotmail Email Accounts for registration

Collapse

Before Access to all Forums and Trial accounts you must need to activate your account Email address

Vu+ Solo - How to flash image with USB stick

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • sonc
    Experienced Board Member
    • Jun 2010
    • 1568

    Vu+ Solo - How to flash image with USB stick

    1. Create a folder in the root of your USB stick called vuplus

    2. Inside the vuplus folder, make another folder called solo

    3. Copy the following USB Image files from your PC to the vuplus/solo folder on your USB stick
    boot_cfe_auto.jffs2
    kernel_cfe_auto.bin
    root_cfe_auto.jffs2

    4. Power-off the Solo

    5. Insert the USB stick in the front USB port of the Solo

    6. Power on the Solo

    The display window will show an orange/red LED constantly lit.
    This means it's reading the data from the USB Pen into the buffer.

    Then...

    The display window will show the orange/red LED flashing.
    This means it's now flashing the data to the receiver.

    Wait until the LED changes to a Green Flashing LED.

    When Green LED is flashing you can now safely power off the receiver and remove the USB Pen Drive.

    Now Power on and wait for the receiver to boot.
  • satmanbasil
    Newbie
    • Dec 2010
    • 4

    #2
    Re: Vu+ Solo - How to flash image with USB stick

    Hi mate

    I would add to your instructions for the sake of newbies that when you remove the usb stick all you need to do is press the Reset button at the rear for a few seconds so the green light goes out then when let go the green light will come back on stable ....loading the image

    regards
    satmanbasil

    Comment

    • blaska
      Member
      • Jul 2010
      • 57

      #3
      Re: Vu+ Solo - How to flash image with USB stick

      Hi,
      I've followed the instructions of how to flash an image via USB stick.
      I've tryed VTI image. When the led went green flashing I turned off the STB and turned on again, then I only get a green steady led and a black screen on tv.
      What did I wrong?

      Thanx.

      Ok, problem solved. The problem was that it takes a lot of time to start. I was scared!!!
      -Vu+ Duo with blackhole 1.45
      -Motsat 3 +120cm dish
      -Cccam 2.2.1
      -local and full card.

      Comment

      Working...