booting problem!?

[bobyx]

Hello,everybody.When I want to change a channel,suddenly my

" STARSAT SR-X95USB " receiver display remove that channel number

and repeatedly displayed; " boot " and after a few seconds just displayed

"boot " .And now whenever I set it ON, it just displays; "boot" .!

If I should download the STARSAT SR-X95USB,s receiver boot loader file into

the receiver to repair it? And how?(from its USB port in the front window

of it from my laptop?)?

And could I upgrade it at this moment?

Would you please attached here the STARSAT SR-X95USB,s receiver boot

loader file, because of my government internet limitations I could not download it,?

Thanks,

[aplok]

Re: booting problem!?

Hello,everybody.When I want to change a channel,suddenly my

" STARSAT SR-X95USB " receiver display remove that channel number

and repeatedly displayed; " boot " and after a few seconds just displayed

"boot " .And now whenever I set it ON, it just displays; "boot" .!

if your image has been working in the past,
i do not understand why it does not anymore now,

except if the channel has been changed ( ie the service 1:0:1:..... in lamedb)
and become obsoletes

i've also experienced such system crash with corrupted bouquets definition on enigma2

so here is my suggestion: proceed a sat autoscan to build a new fresh and clean channel list

do not forget to backup your /etc/enigma2 with all your current bouquets
otherwise vhannibal and co are your friend

enjoy

[saja44]

Re: booting problem!?

if your image has been working in the past,
i do not understand why it does not anymore now,

except if the channel has been changed ( ie the service 1:0:1:..... in lamedb)
and become obsoletes

i've also experienced such system crash with corrupted bouquets definition on enigma2

so here is my suggestion: proceed a sat autoscan to build a new fresh and clean channel list

do not forget to backup your /etc/enigma2 with all your current bouquets
otherwise vhannibal and co are your friend

enjoy

i have istar x30000, my satllite have so this like problem.i dont know why exit from boot mode
please if onebody have solved for this problem ....... thanks

[bobyx]

Re: booting problem!?

Hello,

An interesting experience!!

With thanks to aplok,I should say that I could not scan because my receiver just
displayed; boot.

But, I repaired it by a new idea that may be useful for saja44;
I use a cable with a Rs232 connector in its end and a USB connector on the other of its end:
I connected the rs232 side of that cable to my RS232 receiver port and connect its usb
side to my usb port of laptop and run the easy upgrade boot file for STARSAT SR-X95USB; at my laptop displayed a narrow band filled with blue color and 0% displayed
on it,a COM1 button at left hand side and a start button at the right.Then,I click on the
start button and set on the key power that is on the rear of my receiver and not the front power switch. Receiver displayed,boot for a few seconds and I click on the start button 3 times.Suddenly,my receiver displayed the number 10,that I think that was the
channel 10 for the last time it worked.But, loader did not show any loading proceed!!?

At last, after a 5 minutes,for a caution and confidence,I EXIT from the easyupgrade program,OFF the rear key of my receiver and disconnect the cable and connected my receiver to TV and Dish again,it works very nice!!!
That was very strange and may be to unlock a device by that action?!

Have a nice day,