Welcome!

Welcome to Satlover forums, full of great people, ideas and excitement.

Please register if you would like to take part. link..

Register Now

Alert: Don't Use Hotmail Email Accounts for registration

Collapse

Before Access to all Forums and Trial accounts you must need to activate your account Email address

Noob Guide to patching Technomate

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • sahilkhan
    Senior Member
    • Jun 2011
    • 120

    Noob Guide to patching Technomate

    Guide for the newbies.

    Heres how to load the patches.
    Download the relevant patch and extract.
    Download the relevant loader and extract.
    Connect your receiver to the pc via rs232c cable.
    Choose the correct com port.
    Leave the receiver on standby.
    Open the loader and select the software tab.
    Press browse and find the extracted patch.
    Press ok then start then wait.
    This will take a few minutes. Thats it. The same things need doing for softcams but make sure you use the keys tab. Everything else is the same.

    USB,

    FIRST ALWAYS MAKE SURE YOU USE THE CORRECT PATCH FOR YOUR MODEL
    there are various models and only the correct patch will work or even load on your model
    ************************
    Download the correct patch for your receiver.
    Open the zipped folder and take the patch out ready to transfer the patch onto your usb memory stick.
    Insert your usb memory stick in the usb port under the front flap.
    Turn the receiver on ready to load the patch then press the usb button on your remote.
    on the next screen go to data transfer and click>OK.
    now you will see a panel with the patch on it, it will highlight, [for patching].
    press ok on the highlighted patch then it will load and when it gets to 100% and has loaded, and the receiver has re-booted [turned off and on again] and the channel opens, remove your usb memory stick. you have now loaded the patch and your channels will now open.
    ***************************
    you also load softcams/channel lists/official software etc:in exactly the same way by selecting
    the item you want to load.
    ****************************

    VIA MiniWeb
    make sure your box is connected to your router via ethernet cable
    1.press and hold the power button on the front, while holding turn the power ON, few seconds you will see a number appear on the lcd screen. (that is the ip address of your box,)this would be a number between 2 to 254.
    so your full ip would be something like 192.168.1.x (x is the number that appears on ur box lcd)
    2. now browse to the ip address in any suitable internet browser.
    there you will see a empty field , next to it is browse button > press that and point it to the location of the image file.
    and let it complete it,s process looking at your TV screen, once complete
    Reboot and you are done


    Note: if scrambled channel appears on channels which should open; wait a few minutes. This will enable the auto update to kick in.
  • odysseas1991
    Experienced Board Member
    • Jan 2011
    • 635

    #2
    Re: Noob Guide to patching Technomate

    Very nice, bear in mind that the good thing about technomate, is that it does not allow you to load a wrong patch (as in a wrong model) it will give an error message.

    Comment

    Working...