Updating Relook 400S
1st Download Flash tools from DGStation:
Important: Drivers to 400S USB mode must be installed on the PC first, before you run the program.
Follow these steps:
2nd Connect PC and Relook 400S with USB cable.
3rd Turn off the Relook 400S with a switch on the back.
4th Start the receiver back with the same key, while on the front panel is pressed.
5th Relook display shows "USB upgrade".
6th PC detects new hardware and start the setup.
7th Select the setup using "search for driver".
8th Browse to C: / Programs / Flash_tools / VESTAUSB
9th Select "vestausb.inf" and OK.
10th Click "Finish" when completed.
After software and drivers are installed, you can begin to update the receiver.
11th Proceed as in paragraph 2-5 above.
12th Click the Flash Tools.
13th Click USB at the top. USB Connected is displayed in the application box on the PC at the bottom.
14th Select the image file to the recipient with the FILE button.
15th Click DOWN for the program. Flash Tools start charging the image to the Relook 400S.
16th When everything is ready, Relook 400S shows "DONE" in the front display.
Disconnect the USB cable and restart the receiver.
1st Download Flash tools from DGStation:
Important: Drivers to 400S USB mode must be installed on the PC first, before you run the program.
Follow these steps:
2nd Connect PC and Relook 400S with USB cable.
3rd Turn off the Relook 400S with a switch on the back.
4th Start the receiver back with the same key, while on the front panel is pressed.
5th Relook display shows "USB upgrade".
6th PC detects new hardware and start the setup.
7th Select the setup using "search for driver".
8th Browse to C: / Programs / Flash_tools / VESTAUSB
9th Select "vestausb.inf" and OK.
10th Click "Finish" when completed.
After software and drivers are installed, you can begin to update the receiver.
11th Proceed as in paragraph 2-5 above.
12th Click the Flash Tools.
13th Click USB at the top. USB Connected is displayed in the application box on the PC at the bottom.
14th Select the image file to the recipient with the FILE button.
15th Click DOWN for the program. Flash Tools start charging the image to the Relook 400S.
16th When everything is ready, Relook 400S shows "DONE" in the front display.
Disconnect the USB cable and restart the receiver.