Lnb Loopthrough Problems

[thecrazybandit]

I have connected my lnb loopthrough from my spiderbox to my second tuner on my tv but it is showing no signal should this work ok any advice would be great

[kudok]

Re: Lnb Loopthrough Problems

Receiver Stand-By or receiver "off" from power supply?

Normally it must be Stand-By

[Mobley3]

Re: Lnb Loopthrough Problems

Power saving mode needs to be switched off in Spiderbox settings, if I remember correctly.

regards mobley3

[thecrazybandit]

Re: Lnb Loopthrough Problems

Yes you are correct power saving mode has to be turned off i have tried that i also have turned on second tuner in tuner setting on my panasonic tv but it still shows no signal on second tuner

[rizwan]

Re: Lnb Loopthrough Problems

Check with device, you have some volts from loop out

[Teranoz]

Re: Lnb Loopthrough Problems

Are you sure the cable is ok ? Maybe you should try to use a connector between the cables (without tuner 1) to see if that is ok.
Or try to switch Tuner 1 and Tuner 2 to see if that will work.

[thecrazybandit]

Re: Lnb Loopthrough Problems

Very strange there a signal coming from the box to the tv but it still shows no signal on tuner 2

[Mobley3]

Re: Lnb Loopthrough Problems

Is there any kind of input selection for the tuner input?

regards mobley3

[thecrazybandit]

Re: Lnb Loopthrough Problems

All i have is turn twin tuner mode on or off when turned on it only shows a signal on tuner 1

[Mobley3]

Re: Lnb Loopthrough Problems

What kind of cable are you using to link?

regards mobley3