Tweet
Hi all,
I need some clarifications on the signal level and power measurement methods for the RF system.
I'm using two different test equipment (i.e. Power Meter and Spectrum Analyzer) to check and to verify the data signal level of my hub system.
My concern is the reading of Power Meter is not the same with Channel Power being displayed in the Spectrum although it's being tapped from the same sources. Why does this happen?
Thanks in-adv.
I need some clarifications on the signal level and power measurement methods for the RF system.
I'm using two different test equipment (i.e. Power Meter and Spectrum Analyzer) to check and to verify the data signal level of my hub system.
My concern is the reading of Power Meter is not the same with Channel Power being displayed in the Spectrum although it's being tapped from the same sources. Why does this happen?
Thanks in-adv.