Tweet
Nova 100% working file with loader1.1
1.Download the attached v1.1 loader
2.Connect your R232 cable in com port 1 (Must Be Com Port 1) You can check it is com port 1 set up by clicking start menu, Control Panel, System, Hardware, Devices Manager. Here you should see Com Port Serial Bridge, click on it, see that it on com port 1
3.Now connect cas interface via usb
4.Click on Utilities, then pheonix, select 6.0mhz for laptop or 3.57mhz for desk top. Click HIDE.
5.Open V1.1 loader I give you here in attachment. Make sure you tick 6.0mhz in 1.1 loader window.
6.Now click clean card. If it says NO ATR, take card out of cas programmer and insert it again until it shows ATR, once cleaned click load file. Load the gamma file I posted here that says 24.01.10 quick AU, now click program card. Wait for it to finish then click Program card again. Once finished. Take gamma card out of cas programmer. Go to your receiver and before you put gamma card inside make sure your receiver is already on Nova Cinema 1 (13.0E). NOW insert gamma card. Wait 30 seconds or longer and it will clear channels.
1.Download the attached v1.1 loader
2.Connect your R232 cable in com port 1 (Must Be Com Port 1) You can check it is com port 1 set up by clicking start menu, Control Panel, System, Hardware, Devices Manager. Here you should see Com Port Serial Bridge, click on it, see that it on com port 1
3.Now connect cas interface via usb
4.Click on Utilities, then pheonix, select 6.0mhz for laptop or 3.57mhz for desk top. Click HIDE.
5.Open V1.1 loader I give you here in attachment. Make sure you tick 6.0mhz in 1.1 loader window.
6.Now click clean card. If it says NO ATR, take card out of cas programmer and insert it again until it shows ATR, once cleaned click load file. Load the gamma file I posted here that says 24.01.10 quick AU, now click program card. Wait for it to finish then click Program card again. Once finished. Take gamma card out of cas programmer. Go to your receiver and before you put gamma card inside make sure your receiver is already on Nova Cinema 1 (13.0E). NOW insert gamma card. Wait 30 seconds or longer and it will clear channels.
Comment