Welcome!

Welcome to Satlover forums, full of great people, ideas and excitement.

Please register if you would like to take part. link..

Register Now

Alert: Don't Use Hotmail Email Accounts for registration

Collapse

Before Access to all Forums and Trial accounts you must need to activate your account Email address

motor setup

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • dawbrain
    Member
    • Mar 2013
    • 45

    motor setup

    what is best setup for motor going from thor.8w to bullasat 39e do i set the dish at thor, or 39e, or somewhere in the middle,
  • Mobley3
    Experienced Board Member
    • Jun 2012
    • 722

    #2
    Re: motor setup

    [QUOTE=dawbrain;289399]what is best setup for motor going from thor.8w to bullasat 39e do i set the dish at thor, or 39e,[/QUOTE

    As you are in Ireland your reference sat is in fact 5W.If you are using USALS then that is where you should start from. With the motor set at zero first turn it to a south position. put in you Lat and Long and then send the motor to 5W, adjust for best signal by moving the motor around the pole to peak the signal, tighten the motor mounts. Once this is done the other sats should be found automatically. If you use Diseqc you will have to find and store each sat separately. Hope this helps.

    I presume that you have paid all the necessary attention to making sure that the mounting pole in vertical in both planes, if it is not you will have problems tracking the arc

    Regards Mobley3


    mobley3

    Comment

    • thecrazybandit
      Experienced Board Member
      • Jul 2012
      • 768

      #3
      Re: motor setup

      I think you will find that most people start at 1 west find the best signal on that sat normally bbc news channel and go from there

      Comment

      • kalpikos
        Experienced Board Member
        • Sep 2011
        • 7663

        #4
        Re: motor setup

        Hi mate

        You must find the longitude for your area.
        Irland is near of 8° and that's means that the zero point is the 7E or 9E.
        One of these satellite you must use as start for the right settings.
        If You Like My Post..... Please Press the Thanks Button

        Comment

        • peremacedonia
          Experienced Board Member
          • Jun 2010
          • 872

          #5
          Re: motor setup

          First your place where you put your antena must be 90d.

          You must find true sout with compas,there is your start position
          Next go here to calculate your azmuth and elevation angle

          Configure disq in dreambox
          Rule n.33 kid..... Concentrate

          Comment

          • bmitie
            Vip Member
            • Sep 2011
            • 9

            #6
            Re: motor setup

            hi, did you get sorted, and what receiver are you using? it depends in ireland where you are located on deciding the best satellite to use as your reference sat. the more west you go then you need a more westerly sat. but at 8west you are near cliffs of moher so wont need to go anyfurther.

            Comment

            Working...