Welcome!

Welcome to Satlover forums, full of great people, ideas and excitement.

Please register if you would like to take part. link..

Register Now

Alert: Don't Use Hotmail Email Accounts for registration

Collapse

Before Access to all Forums and Trial accounts you must need to activate your account Email address

Gamma Card Latest File

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • khurramdar
    Banned
    • Jan 2010
    • 138

    Gamma Card Latest File

    1.Download the attached v1.1 loader
    2.Connect your R232 cable in com port 1 (Must Be Com Port 1) You can check it is com port 1 set up by clicking start menu, Control Panel, System, Hardware, Devices Manager. Here you should see Com Port Serial Bridge, click on it, see that it on com port 1
    3.Now connect cas interface via usb
    4.Click on Utilities, then pheonix, select 6.0mhz for laptop or 3.57mhz for desk top. Click HIDE.
    5.Open V1.1 loader I give you here in attachment. Make sure you tick 6.0mhz in 1.1 loader window.
    6.Now click clean card. If it says NO ATR, take card out of cas programmer and insert it again until it shows ATR, once cleaned click load file. Load the gamma file I posted here that says 24.01.10 quick AU, now click program card. Wait for it to finish then click Program card again. Once finished. Take gamma card out of cas programmer. Go to your receiver and before you put gamma card inside make sure your receiver is already on Nova Cinema 1 (13.0E). NOW insert gamma card. Wait 30 seconds or longer and it will clear channels.
    Attached Files
Working...
X