Welcome!

Welcome to Satlover forums, full of great people, ideas and excitement.

Please register if you would like to take part. link..

Register Now

Alert: Don't Use Hotmail Email Accounts for registration

Collapse

Before Access to all Forums and Trial accounts you must need to activate your account Email address

diseqc 2in1 reduse my signal 35%

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • KVF1966
    Board Senior Member
    • Dec 2012
    • 279

    #16
    Re: diseqc 2in1 reduse my signal 35%

    Sometimes it is a problem with oxidation of the cable and then the signal level falls. You need to clean up the Central core of the cable and check the connector

    Comment

    • tech1010
      Member
      • Oct 2012
      • 86

      #17
      Re: diseqc 2in1 reduse my signal 35%

      Yes it is right.. But in case of dreambox long wire creates more problem.. I reduced length of cable from box to switch so my problem solved..
      did lots on dish tv sun dth india

      Comment

      • digicon
        Experienced Board Member
        • Jun 2011
        • 971

        #18
        Re: diseqc 2in1 reduse my signal 35%

        Diseqc switches usually lose between 2-3db depending on the brand of switch, this has no bearing on whether the switch is connected near your dish or behind your receiver the signal loss would still be the same.

        Comment

        • sat_sat27
          Experienced Board Member
          • Mar 2012
          • 740

          #19
          Re: diseqc 2in1 reduse my signal 35%

          Same was happened with me???????????

          Comment

          • easydigital
            Board Senior Member
            • Nov 2010
            • 289

            #20
            Re: diseqc 2in1 reduse my signal 35%

            Can a 2-1 DISEqC switch pass the signal from the two inputs simultaneously?
            helped use "Thanks"

            Comment

            • Satphoenix
              Experienced Board Member
              • Oct 2012
              • 999

              #21
              Re: diseqc 2in1 reduse my signal 35%

              Originally posted by easydigital
              Can a 2-1 DISEqC switch pass the signal from the two inputs simultaneously?
              In yes, out no.

              It's a switch which switches one of the inputs to the output. During this process you lose a (very) little bit of your signal strength. With a good switch you won't realise this loss.
              If you want to make God laugh, tell him your plans!

              Comment

              • kalpikos
                Experienced Board Member
                • Sep 2011
                • 7663

                #22
                Re: diseqc 2in1 reduse my signal 35%

                Dear friend
                You probably have a faulty DiSEqC Switch.

                Buy a new one with better quality (not from e-bay)
                but first...
                check your settings of your box.

                Maybe you have miss to check or uncheck something.

                Take a careful look at your settings and inform us.

                Best regards
                If You Like My Post..... Please Press the Thanks Button

                Comment

                • zoran89
                  Experienced Board Member
                  • Mar 2010
                  • 1618

                  #23
                  Re: diseqc 2in1 reduse my signal 35%

                  Yes it is faulty switch.

                  for the future usualy Switch is placed close to the dish and if you have amplifier you put it close to reciver.

                  Comment

                  • gianni253
                    Experienced Board Member
                    • Nov 2012
                    • 903

                    #24
                    Re: diseqc 2in1 reduse my signal 35%

                    Originally posted by zoran89
                    Yes it is faulty switch.

                    for the future usualy Switch is placed close to the dish and if you have amplifier you put it close to reciver.
                    I wouldn't put amplifier near the receiver ... in this way you are going to amplify a signal with a bigger noise.
                    Typically amplifiers should be kept as near as possible to the signal's source, where you have a better S/N ratio.

                    Comment

                    • zoran89
                      Experienced Board Member
                      • Mar 2010
                      • 1618

                      #25
                      Re: diseqc 2in1 reduse my signal 35%

                      I couldnt agree, I test it few times and best result is closest to reciver.
                      There is no need for amplify signal close to LNB, but when signal is lost throught the cable.

                      Comment

                      • Satphoenix
                        Experienced Board Member
                        • Oct 2012
                        • 999

                        #26
                        Re: diseqc 2in1 reduse my signal 35%

                        Originally posted by tech1010
                        Yes it is right.. But in case of dreambox long wire creates more problem.. I reduced length of cable from box to switch so my problem solved..
                        Then you had an old or very cheap cable.
                        I am using since a few weeks a 50m cable from receiver to switch and have no diseqc problems.
                        If you want to make God laugh, tell him your plans!

                        Comment

                        • gianni253
                          Experienced Board Member
                          • Nov 2012
                          • 903

                          #27
                          Re: diseqc 2in1 reduse my signal 35%

                          Originally posted by zoran89
                          I couldnt agree, I test it few times and best result is closest to reciver.
                          There is no need for amplify signal close to LNB, but when signal is lost throught the cable.
                          I respect your opinion and tests, but on the web you will find plenty of pages like this:
                          __hxxp://www.satcure.co.uk/tech/lnbamps.htm

                          Just quoting from the above link:
                          "The amplifier will give no benefit as it amplifies only what is there - signal plus noise - and adds more noise.
                          To spell it out: Connect your receiver as close to the dish as possible."

                          or ...

                          "The amplifier must always be near the input end of a long cable. If you put it at the output end, you are simply boosting the signal and the noise the cable has picked up, so you are hardly any better off!

                          If, when you do the test, you find that the receiver does not work better when connected close to the LNB then an amplifier will NOT help. In fact it will almost certainly make matters worse."

                          Comment

                          • kostis
                            Experienced Board Member
                            • Nov 2012
                            • 521

                            #28
                            Re: diseqc 2in1 reduse my signal 35%

                            Some post make me think cause me cable is almost 100% uncover from rain and sun and near 7 years old. too cheap and easy to replace it if it will do me any good. my signal without the diseqc was near 75%. whats the rate for that poor, good, great?
                            If my post was useful, please, use "Thanks" button

                            Comment

                            • pan1300
                              Experienced Board Member
                              • Apr 2012
                              • 1663

                              #29
                              Re: diseqc 2in1 reduse my signal 35%

                              Originally posted by kostis
                              Some post make me think cause me cable is almost 100% uncover from rain and sun and near 7 years old. too cheap and easy to replace it if it will do me any good. my signal without the diseqc was near 75%. whats the rate for that poor, good, great?
                              hi kostis

                              75% seems good to me (not poor, but surely not great either) - I don't expect problems with this.

                              Comment

                              • kostis
                                Experienced Board Member
                                • Nov 2012
                                • 521

                                #30
                                Re: diseqc 2in1 reduse my signal 35%

                                Originally posted by pan1100
                                hi kostis

                                75% seems good to me (not poor, but surely not great either) - I don't expect problems with this.
                                yes no signal loss so fur except from very rainy days, and the last lnb change was made with no instruments use so i take it the wire is ok for now.
                                If my post was useful, please, use "Thanks" button

                                Comment

                                Working...