Hop priority

[kef7878]

Hello guys. Sometimes in a cline, a hop 2 provider is better than hop 1. Is there any way to set this priority? I want to exclude for example a caid from hop 1, but receive that caid from hop 2.

Any tips?

Or, do i have to use the prio file, and exclude all the hop 1 caids specifically?

Regards

[vimmers]

Re: Hop priority

the only way would be this
this are almost the same you asking for and will work

block the cards there not open your channels
you do that by looking into tmp
after the ecm file
open it and look after this
share: *********xx_***xx <--- this is tha card you vill block
now write this in your cccam.cfg
IGNORE NODE: *********xx_***xx
remember that only open the ecm.info
when you stay on the channel there not open
or else you block a card you will not block
after done reboot enigma or restart box

i have explained this in several other post

[kef7878]

Re: Hop priority

Thanks for your post.

Maybe i made myself unclear...I have 10 shares under hop 1. I need to block all 10 and go straight for hop 2. Your saying i need to go to the tmp file, block share in the ecm file, but do i have to first block the first share, restart, then check next share on hop 1, block that, restart etc, until i reach hop 2?

Are there no easier way?

[vimmers]

Re: Hop priority

no you wasn't unclear
you just do the same 10 times then
IGNORE NODE: *********xx_***xx
IGNORE NODE: *********xx_***xx
and so on
if you download cccaminfo.php
then you can see all your shares
a easier way

[kef7878]

Re: Hop priority

I just tested this. When i use one of satlovers clines and add an IGNORE NODE: *********xx_***xx to cccam.cfg, press save...restart....I simply get 0 shares from the satlover cline seen on CCcaminfophp. Any tips? No channel clears...

Brgs

[topman96]

Re: Hop priority

but dont the nodes id number change every time you swith of dreambox and reboot

[vimmers]

Re: Hop priority

only at server end topman96
kef7878 maybe you got it wrong
a share will looks like this
system: Conax
caid: 0xb00
provider: Akta/Kabel Kiosk/TVN/DigitAlb/Technisat/My TV/T-Home/Magio Sat/Starmax HD (5E/9E/13E/16E/19E/68E/4W/30W) Comhem SE [DVB-C]
provid: 0x000
pid: 0x0c9
using: CCcam-s2s
address: cccam.satlover.com:99999
hops: 1
share: 94107990e011920c_9794<----this is the node you shall use
ecm time: 0.544

the node will look different on all cards
this is the only way you can block a card
you can't block a specific card in prio file

[vimmers]

Re: Hop priority

here are 2 screenshots from cccaminfophp
_http://img.photobucket.com/albums/v625/vimmers/sat1.jpg
then you get this
_http://img.photobucket.com/albums/v625/vimmers/sat2.jpg