nline

[rob45]

have been trying to put nline in a spiderbox can put cline in no bother if i try to enter one by putting a n instead of a c it wont load if i leave it as c it loads ok then i change it to newcamd and apply but nothing happens question is am i doing it right tried to do it manualy but some of the symbols arent there so have to use usb thanks in advance.

[sataday]

Re: nline

It sounds like you are trying to enter something that you don't need to. If you give an example of what you are trying to enter, we will help you.

Have a look at this thread rob, it may help you.

http://www.satlover.com/forum/satellite-discussion-english/36468-help-to-load-newcamd-by-usb.html

[fandm]

Re: nline

Hi I think if you load as a cline into a con fig file by usb when entered change the cccam to ncam.

[rob45]

Re: nline

hi fandm do you meen when i load the config file to change it to newcamd thats what i do but it just knocks off my premium lines then they reconnect and the newcamb line just says disconnected.

[toby69]

Re: nline

have been trying to put nline in a spiderbox can put cline in no bother if i try to enter one by putting a n instead of a c it wont load if i leave it as c it loads ok then i change it to newcamd and apply but nothing happens question is am i doing it right tried to do it manualy but some of the symbols arent there so have to use usb thanks in advance.

rob45, have a look at thread, how to load newcamb by usb, on page 3, plenty of help there about newcamb, saves a lotta double posting.

[rob45]

Re: nline

hi sataday just read that post and i think what i was doing wrong is leaving the symbolls in when i pasted them in so i will give it another try i will let you know if all ok.

hi toby69 just read your post thanks for info hopefully gone past another stage.

hi guys still no joy left the symbolls out tried again then tried manually no joy had enough for today misses keeps on moaning will try again another day.

[rbonchev]

Re: nline

have been trying to put nline in a spiderbox can put cline in no bother if i try to enter one by putting a n instead of a c it wont load if i leave it as c it loads ok then i change it to newcamd and apply but nothing happens question is am i doing it right tried to do it manualy but some of the symbols arent there so have to use usb thanks in advance.

rob45 I thing that you forgot to leave space between host,port,name and passoword. I had the same problem before.

[rob45]

Re: nline

hi managed to sort it in the endthe problem was the id once i got that right everything ok.