Tweet
Works only on the Premium with HDD installed inside
This will be useful to those who use all sorts of third-party programs AzBOX Type Transmission, litehttpd etc.
In the enclosure file whose name ends with a finished script, which itself creates a paging file, it is swapfile at the start and mount the system.
Installation:
1. Expand the archive into / DISK2/etc/service.d /
2. Writing the execution.
4. We give through telnet
Code:
sync
sync
poweroff
5. Switch off the rear button box and switch on back.
The first time boxing boots seconds longer than at 15, the display will see the inscription PREPARING, then SWAP ON, further load time will not increase.
After downloading the climb on a box via telnet, and if everything is in order to free the team will see that the swap is activated:
MMP [service.d] $ free
total used free shared buffers
Mem: 101500 97872 3628 0 412
Swap: 102392 0 102392
Total: 203,892 97,872 106,020
Now swap is always active, provided that the screw is present on the spot.
download
This will be useful to those who use all sorts of third-party programs AzBOX Type Transmission, litehttpd etc.
In the enclosure file whose name ends with a finished script, which itself creates a paging file, it is swapfile at the start and mount the system.
Installation:
1. Expand the archive into / DISK2/etc/service.d /
2. Writing the execution.
4. We give through telnet
Code:
sync
sync
poweroff
5. Switch off the rear button box and switch on back.
The first time boxing boots seconds longer than at 15, the display will see the inscription PREPARING, then SWAP ON, further load time will not increase.
After downloading the climb on a box via telnet, and if everything is in order to free the team will see that the swap is activated:
MMP [service.d] $ free
total used free shared buffers
Mem: 101500 97872 3628 0 412
Swap: 102392 0 102392
Total: 203,892 97,872 106,020
Now swap is always active, provided that the screw is present on the spot.
download