problems with the motor 800 solo

[joseram2000]

need any special configuration to operate the satellite change? With the same cable and HD300 mvision net is properly Someone with you? and as it has solved thanks

Nobody uses motor Gigablue hd solo?
The same motor with the same settings in dreambox ok, in Gigablue ko, someone help me? thanks

[bokkie]

Re: problems with the motor 800 solo

From my undrstanding the dish and motor are already installed and you just want to change the stb? All you should need to do is configure it to positioner in your settings, enter your longitude and latitude, and you should be good to go.

[knot2]

Re: problems with the motor 800 solo

I sometimes do not always worked I used: azbox engine sat tracer enigma 2. The engine sometimes wrong some satellites could take others not at the engine above the 21 east did not want to go

[joseram2000]

Re: problems with the motor 800 solo

that's not the problem is properly configured with decos as dreambox 800 works fine, the engine does not work well with 800solo being properly configured. latitude and longitude, so I want to know if anyone has the same problem as me, thanks

[joseram2000]

Re: problems with the motor 800 solo

nobody uses this deco? motor?