V-Box Programming

[anacondama]

Go to Menu >> Setup

Press OK than choose Service Searching


then Satellite Configuration

Then Motor Setup

Don't change anything in the current page just choose Next Page

choose the Satellite that you want to set up with the V-Box

Choose a good Trapsporder that can allow you to have strength signal

Now go to Direction and Press Vol + / Vol - buttons to move the dish until you get a good signal


After that you can start the channels searching

choose your channels options


while finishing choose store to save your data

after an other screen will ask you if you want to set up others satellites if yes press green button else the red one

.

PS : Shared post/Personal Writing

Enjoy!