dead dm 800pro

[munimsuri]

could anybody guide me where to take my dm 800hdpro for repair in pakistan..i have already tried rawalpindi and lahore but to no avial

[vimmers]

Re: dead dm 800pro

what is your problem someone can maybe guide you

[munimsuri]

Re: dead dm 800pro

it was behaving oddly since one month then with a loud noise it went dead
doesn't boot ...no lights on lcd.....but lights are blinking at the LAN connector
does not let me upgrage the software via dream or any other software even with rs 323 cable

[gianni253]

Re: dead dm 800pro

First check your psu: connect it to a 12 ohm - 10W resistor (to load it with 1A) and read the voltage that should be around 12Vcc.
You could also use an auto lamp (12v) as load, but check well the power.

If psu is ok, the noise you reported makes me think to a component that is exploded or similar so, if you open the box, at a close inspection you should see the component that is broken (maybe a capacitor ?) and you can try to replace it by yourself.
Let us know.

[rizwan]

Re: dead dm 800pro

IT should be repaired by any expert, otherwise you damage other components

[microchick]

Re: dead dm 800pro

could anybody guide me where to take my dm 800hdpro for repair in pakistan..i have already tried rawalpindi and lahore but to no avial

Hi, There is a dedicated Pakistani forum on the web about the satellites, CS and other issues. Have a look or PM the ADMIN. They might be able to help with the repair. You need to register yourself first. Registration is free.

--http://www.pakistani-forum.com/forum/

[toby69]

Re: dead dm 800pro

Hi, There is a dedicated Pakistani forum on the web about the satellites, CS and other issues. Have a look or PM the ADMIN. They might be able to help with the repair. You need to register yourself first. Registration is free.

--http://www.pakistani-forum.com/forum/

and if you join that site, minimsuri, check out all the satlover cline cheats there, and report

here >>> http://www.satlover.eu/forum/site-bu...tml#post256503

hope you get box fixed, perhaps best to buy new one.

[mahrkpat]

Re: dead dm 800pro

IT should be repaired by any expert, otherwise you damage other components

Sometimes you can save your self a lot of money by just unscrewing a few
screws and taking a look 7 times of 10 when I have done this with other
electronic equipment it has been as simple as a blown fuse the cost a
few pennies.