How to recover your DM800 SE Clone with SunRay-FlashUp and Browser

[aberdojde]

How to recover your DM800 SE Clone with SunRay-FlashUp and Browser

We all make mistakes sometimes and load images we should not be loading. The box will go "bananas" and sometimes display "Err01 cas not found"

First you need a USB-A To mini-usb-B to connect to service socket on back of receiver, and a Network cable to Connect Receiver to PC







-- Then you need to
1 -- Get Sunray -Flashup for 800hdse/500hd http://www.sat4fun.co.uk/showthread....amup-For-800SE
2 -- Because sometimes a patched image will not do the trick, i did chose for this manual the factory loaded image and the correct SSL82 for this box

Here the All russian image http://www.sat4fun.co.uk/showthread....e-for-DM800-SE

Here the SSL82 For DM800SE http://www.sat4fun.co.uk/showthread....p-SIM2.10-card

Now you have all, lets follow pictures to make it easier



1--- Connect USB cable to service slot on DM800SE/DM500HD and USB slot on Pc. Windows will then install the driver as per bellow





You will notice, windows created a virtual Com Port connection to be be used ( in this case Com Port 4)






2 --- Switch Receiver off and connect Network cable to Pc
3 --- Then Start SunRay- FlashUp, Tick Use Network, Fill the relevant boxes with local pc IP and Romote ip of your choise and click Connect.

Program will ask for you to Switch on the receiverIt will show as per Bellow



4 -- It will then go into HTTP mode



5 -- At this stage, you open your browser and insert the romote IP you chose when setting the Sunray. In this case 192.168.0.12. Page will open as per bellow and then you chose the option Update Firmware.



6 --- A page like this will open and you click Browse to take when your image is



7 --- Chose the image and click Open



8 --- It will then go into the field as per bellow and you click Flash




9 --- Image will start writing to Dreambox's Flash as per picture



10 --- When it finishes you can click the back button of your browser




11- .. and chose the SSL82 for your DM800SE Clone



12 --- Once again Click Flash


13 -- After finishing click Reboot. In Most case you will need to do so manually



11- Box will then reboot and come back to life with image we chose to load. Then you can load your Patched image of your coice as box is functional again