help with new sat on dreambox

[topman96]

can any body help i have up dated my dreambox with Catseye E2 Settings File 75 East-58 West but when i look at my sat list i have 1w and also 0.8w now i can reciev the channels on 1w but my sat list shows the 0.8w as a sat but the channels are greyed out so i go in to my reciever and search through the sats in the tuner config but the o.8w is not the as a sat i can chose to enable can any body tell me what i have to do to make 0.8w show up on my tuner config
thanks

[vimmers]

Re: help with new sat on dreambox

are u using motor since u use motor settings
then u have to set it up so it also can see that sat
if u only use a diseqc then u can follow this steps in advanced mode
_http://www.satlover.com/forum/123066-post8.html
but since the 1,0w and 0,8w are same lnb it would be
as this setting

satellite Thor 1,0w
lnb4
diseqc mode 1.1
committed diseqc command bb
command order committed uncommitted tonebust
uncommitted diseqc command input 1

satellite Thor 0,8w
lnb4
diseqc mode 1.1
committed diseqc command bb
command order committed uncommitted tonebust
uncommitted diseqc command input 1

[alfred_1]

Re: help with new sat on dreambox

I have just applied Catseye E2 Settings to my DB and only 1 sat comes up, that is1W and I don't have any 0.8 W with greyed Channels. I am using a Positioner with my Actuator and therfore I am not using Usals. Now as I see it either use the 1W as it is or use another E2 setting. Otherwise I think the only chance to use the 0.8 is to insert that whole Satellite with Dreambox Edit.