Oscam cannot read Smarg ! Help please!

[pazitush]

Using DM800 (Sunray- clone) with Nemesis&Oscam. All drivers &cfg of Smargo installed . Reader cannot be activated . Checked by Linux commnds (telnet) and smartreader is installed Usb0 port. What's wrong? Any help??

[gianni253]

Re: Oscam cannot read Smarg ! Help please!

Not easy to help you with no clues ...
You should post at least your oscam config files and oscam log.
Bye

[SatWaveDude]

Re: Oscam cannot read Smarg ! Help please!

You need to post oscam.server settings and do telnet "lsusb" to now what bus and device address is your smargo on.
that you need to setup you reader!

[pazitush]

Re: Oscam cannot read Smarg ! Help please!

At last success with right Cfg, but , still no picture. Here's from Log:

2013/03/31 15:04:31 0 --- Skipped 6 duplicated log lines ---
2013/03/31 15:04:31 5293C0 c Start descrambling PID #0 (CAID: 0B00) 1
2013/03/31 15:04:31 5293C0 c ERROR: Can't open device /dev/dvb/adapter0/ca3 (errno=16 Device or resource busy)

lsusb=

root@dm800se:~# lsusb
Bus 003 Device 001: ID 0000:0000
Bus 003 Device 002: ID 0403:6001 Future Technology Devices International, Ltd F
232 USB-Serial (UART) IC
Bus 004 Device 001: ID 0000:0000
Bus 002 Device 002: ID 0bda:8172 Realtek Semiconductor Corp.
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 001: ID 0000:0000

Any solution ??

[SatWaveDude]

Re: Oscam cannot read Smarg ! Help please!

do you have installed the usb drivers for smargo?
I'm not 100% shure on how to do that on an DM800 but you shall ****** for it.
The smargo needs also FTDI usb drivers but again I dont now howto on DM800.

Sometimes if drivers are installed smargo wil not work due a program conflict then you need to de-install britty "apt-get remove brltty"

Let us now how you proceed others may have this problem too.

[pazitush]

Re: Oscam cannot read Smarg ! Help please!

FTDI Usb drivers installed. It seems that really there was conflict with Cccam still running with the Oscam. So Killed it and now Ok. Tried also to connect another Smargo to the USB1 port but then all stopped again . Is there a specific solution for this also ?

[gianni253]

Re: Oscam cannot read Smarg ! Help please!

FTDI Usb drivers installed. It seems that really there was conflict with Cccam still running with the Oscam. So Killed it and now Ok. Tried also to connect another Smargo to the USB1 port but then all stopped again . Is there a specific solution for this also ?

You can't access the same card reader with oscam and cccam at the same time (and you don't need it !).
If you connect a second card reader, then you must define it to oscam with a second "[reader]" section in oscam.server.