config & prio file

[pan1300]

Re: config & prio file

hi Blue

perhaps you can find some ideas here: http://www.satlover.eu/forum/cccam/1...ccam-prio.html

btw: I do the same: just enter the cline, nothing less, nothing more, works fine for me.

[BlueIsMyColor]

Re: config & prio file

hi Blue

perhaps you can find some ideas here: http://www.satlover.eu/forum/cccam/1...ccam-prio.html

btw: I do the same: just enter the cline, nothing less, nothing more, works fine for me.

i was only talking about cccam.cfg, not cccam.prio. Regards

[vimmers]

Re: config & prio file

Another question:

How do you have your cccam.cfg configurated? I only put the cline and nothing more. But when i analyse the original cfg file there are a lot of things to configure. Is there a way to optimize cccam.cfg file for client only?

you can e.g look at the nodeid and block a certain receiver
# Option to ignore all shares that go through a certain node
#
#IGNORE NODE: <nodeid>
#
#example, ignore two nodes:
#
#IGNORE NODE: ccd536ab515767ad
#IGNORE NODE: aad536ab515761af
you find the nodeid by looking at ecm file
and to block the receiver
you write IGNORE NODE: aad536ab515761af without the # in front
in your cfg file
ecm file are found in tmp