Tweet
Hi,
Has anyone had any experience with this device: http://www.cardlink.nl/
It is intended to give CS capabilities to receivers that do not have a network connection.
Im thinking - with it having CCcam onboard - you should be able to provide the Boxkey from your original providers box - pairing the card to the box.... Enabling you to use your original providers box (some of them have nice interfaces
)
Hardware:
· ISO 7816 dual sided smartcard interface
· 120Mhz RISC CPU
· 576Kb Flash Rom
· Status Leds
· RJ45 Ethernet connector (10Base-T)
Software:
Card share protocol: Newcamd/Cardserver, NewCS
Network protocols: TCP/IP, DHCP, DNS
Card emulation: Seca/Mediaguard, Irdeto, Viaccess, Conax
Security: 3DES/MD5 encryption
Built in webserver
Software upgradeable
Frequently asked questions(F.A.Q.)
Q: What kind of cardserver should i use?
A: Cardlink works with NewcamD and NewCS cardserver software, running on a dreambox, relook or linux-pc with CS software.
Q: What cards are supported for sharing?
A: Cardlink can currently emulate Seca, Irdeto, Viaccess and Conax cards.
Q: Which receivers do not work with Cardlink?
A: Some receivers with embdedded Irdeto or Viaccess don't work with the cardlink. However, most of them work fine. Please check the Isat.nl forum for a list of compatible receivers.
Q: How should i connect the powersupply?
A: The powersupply should be 6 Volts, the center tip is the + terminal.
Has anyone had any experience with this device: http://www.cardlink.nl/
It is intended to give CS capabilities to receivers that do not have a network connection.
Im thinking - with it having CCcam onboard - you should be able to provide the Boxkey from your original providers box - pairing the card to the box.... Enabling you to use your original providers box (some of them have nice interfaces
)Hardware:
· ISO 7816 dual sided smartcard interface
· 120Mhz RISC CPU
· 576Kb Flash Rom
· Status Leds
· RJ45 Ethernet connector (10Base-T)
Software:
Card share protocol: Newcamd/Cardserver, NewCS
Network protocols: TCP/IP, DHCP, DNS
Card emulation: Seca/Mediaguard, Irdeto, Viaccess, Conax
Security: 3DES/MD5 encryption
Built in webserver
Software upgradeable
Frequently asked questions(F.A.Q.)
Q: What kind of cardserver should i use?
A: Cardlink works with NewcamD and NewCS cardserver software, running on a dreambox, relook or linux-pc with CS software.
Q: What cards are supported for sharing?
A: Cardlink can currently emulate Seca, Irdeto, Viaccess and Conax cards.
Q: Which receivers do not work with Cardlink?
A: Some receivers with embdedded Irdeto or Viaccess don't work with the cardlink. However, most of them work fine. Please check the Isat.nl forum for a list of compatible receivers.
Q: How should i connect the powersupply?
A: The powersupply should be 6 Volts, the center tip is the + terminal.