Re: Help please
ok my friend, make the necessary changes and then inform the forum about your progress.
Be aware that there is a special satellite cable that you have to use and don't buy just a tv cable.
It's a little more expensive but has better insulation and ofcourse gives better results.
Alert: Don't Use Hotmail Email Accounts for registration
Collapse
Before Access to all Forums and Trial accounts you must need to activate your account Email address
Help please
Collapse
X
-
Re: Help please
theres no way i can try out the box at a friends so im going to get some new satellite cable and try that it may be a few days until i reply but i thank all of you for your help and timeLeave a comment:
-
Re: Help please
hi afc4life
and extra to @kalpikos' post: did you try your box at a friend (to be sure the box/tuner is ok)?Leave a comment:
-
Re: Help please
A sat cable it's better to be without cuts or to be connected with thinner - thicker cable.
What is this connector which joining the cable that you have?
Is it a diseqc switch or something else?
It would be very convenient if you have a friend with a receiver in order to test it in your home to find if your dish installation is ok.Leave a comment:
-
Re: Help please
Hi i had a quick check last night im wondering if its a cable issue as the cable from dish is joined via a connector to a thicker cable that runs to the reciever coyld this be an issueLeave a comment:
-
Re: Help please
If you can't watch any free channel, then propably you have problem with your dish alignment or you have a faulty lnb or a cut wire or just you don't have the correct settings on your receiver.
It would be better to give us more info about your dish setup, cables, lnb, satellite configuration on the dreambox in order to help you further.Leave a comment:
-
Re: Help please
Hello
If you have signal, then you can watch FTA channels.
If I'm not wrong, you have only one dish with one lnb to Astra 28E (sly dish).
Make a factory reset, and setup again your dreambox.
First set the Astra 28E as the only satellite you have and then make a scan.
After that, you will be able to watch at least the FTA channels.
If not, then you have problem with your dish or lnb or cable.
If you can watch FTA channels, then you can proceed to instal cccam and after that to test a C-line.Leave a comment:
-
Re: Help please
Hello
If you have signal, then you can watch FTA channels.
If I'm not wrong, you have only one dish with one lnb to Astra 28E (sly dish).
Make a factory reset, and setup again your dreambox.
First set the Astra 28E as the only satellite you have and then make a scan.
After that, you will be able to watch at least the FTA channels.
If not, then you have problem with your dish or lnb or cable.
If you can watch FTA channels, then you can proceed to instal cccam and after that to test a C-line.Leave a comment:
-
Re: Help please
hi yes signal is strong but as stated nothing showing im thinking if theres a problem with the dish or at least the cable from the dish,but surely if that was the case i wouldnt get a signal.Leave a comment:
-
Re: Help please
hi afc4life
if fta channels aren't ok: start to focus on this instead of scrambled channels and clines ; take a back-up of your channels and settings, rescan your sats - do you have signal? and quality?Leave a comment:
-
Re: Help please
Not getting fta channels not a thing i must be doing something wrong is this the right setup-cable from sly dish to cable in on dreambox- dm connected to laptop and router-cline in var/ect/camfig.thank you for your continue patienceLeave a comment:
-
-
Re: Help please
What do you see in DCC?
Are they all connected?
Can you see any addon or plugin in downloads? (from the server of the image that the receiver can download)
I make these questions in order to understand if the connection is right or not.
Also, there is a test that you can do (in network settings) to find if the connection is ok.
If your problem is the c-line and the lines from satlover are not working, you can make a search on the net to find a free test line for 24h to test it.Leave a comment:
-
Re: Help please
What do you see in DCC?
Are they all connected?
Can you see any addon or plugin in downloads? (from the server of the image that the receiver can download)
I make these questions in order to understand if the connection is right or not.
Also, there is a test that you can do (in network settings) to find if the connection is ok.
If your problem is the c-line and the lines from satlover are not working, you can make a search on the net to find a free test line for 24h to test it.Leave a comment:
-
Re: Help please
done all of above nothing happening tried about thirty lines so dont know whats the problemLeave a comment:
Leave a comment: